Shenzhen GK Lighting Co.,Ltd.
LED modules and LED strips lighting expert
MJW154B, 1 lamp 1.2W 3030 with optical 15x45 ° injection module
- Commodity ID: MJW154B
LED High-power Module
1. Product description:
1. It adopts high-quality 3030 light source, which has the characteristics of high brightness, uniform light color and strong antistatic ability;
2. It adopts DC12V power supply, constant voltage circuit drive mode, and single lamp can be cut;
3. Equipped with 15x45° optical lens, the appearance Beautiful, the PCB adopts high-conductivity aluminum substrate, and the heat dissipation effect is good;
4. The module adopts ABS half-pack injection molding process, flame retardant grade UL94V-0, protection grade IP65.
Application places: mainly used in 8-12cm guide sign light boxes, etc.
2. Product parameters:
Standard cascade (Typ):
a fixed way:
Glass glue or screw ST2.5x10mm
White release paper blue 3M lettering adhesive
Number of LEDs:
3. Product light source parameters:
LED optional color temperature/wavelength
LED luminous flux/brightness
The final interpretation right of this product belongs to Guangke Lighting, and it is subject to change without prior notice.
4. Spot diagram and light distribution curve diagram:
5. Schematic diagram of product dimensions (unit: mm):
6. Schematic diagram of product installation and wiring:
7. Product application:
Light box thickness mm
Light box size mm
Lighting spacing mm
Actual dosage PCS
Installation density PCS/m²
24-hour bank guide light box
500mm single side lighting
hollow light box
1.2m single side lighting
hollow light box
1m single side lighting
Double-sided light boxes for subways, airports, and commercial centers
1.5m up and down lighting
8. Matters needing attention in product installation and use:
(1). Use 2x1.5mm² or more cables for the main power line (choose the corresponding main power line according to the load current). If the module power line needs to be lengthened, you must use a wire with a specification above 0.75mm²/18# to avoid overloading and overheating the power line.
(2). The single lamp of the module can be cut. When the module is cut short and connected, first use diagonal pliers to cut the power cord between the two modules in the middle, peel off the outer skin about 10mm, and put the corresponding color ( The white and red strips are the positive pole, and the white and blue strips are the negative pole) the wires are twisted into one strand, and then insulated and waterproofed with a special waterproof tape. It is advisable to pull out;
(3). When installing the module, first tear off the release paper at the bottom of the module, stick it to the light box or the advertising logo for preliminary fixation, and then use 2 ST2.5x10mm self-tapping screws to lock and reinforce , and can also be fixed by applying glass glue on both sides of the module;
(4). The terminal module wires need to be waterproofed with waterproof tape or wiring waterproof plugs to avoid short-circuit damage to the product;
(5). Module standard level Connect 20PCS, use DC12V single-end power supply; maximum cascade 40PCS, use both ends of power supply, do not overconnect, to avoid excessive line load current and damage the product;
(6). Live touch, live work.
Note: It is recommended to use a switching power supply (with short-circuit protection, over-voltage protection, and over-current protection) that has passed the relevant safety certification.