Shenzhen GK Lighting Co.,Ltd.
LED modules and LED strips lighting expert
MFW150D1 One lamp 0.36W 2835 constant current injection molding module with lens
- Commodity ID: MFW150D1
LED 2835 Module
1. Product description:
1. It adopts high-quality 2835 light source, which has the characteristics of high brightness, uniform light color, and strong antistatic ability;
2. It adopts DC12V power supply and linear constant current drive mode;
3. Equipped with optical lens, the appearance is beautiful, and the PCB adopts high conductivity aluminum The substrate has good heat dissipation effect;
4. The module is made of fireproof material, the fireproof level can reach U94V-2, and the protection level is IP65.
Application places: suitable for 6-12cm advertising signboard characters, advertising light boxes, etc.
2. Photoelectric parameters:
Connecting wire material:
Number of LEDs:
3M white adhesive
3. Light source parameters:
LED color temperature
LED luminous flux/brightness
4. Schematic diagram of product dimensions: (unit: mm):
5. Schematic diagram of product installation and wiring:
6. Matters needing attention in product installation and use:
(1). Use 2x1.5mm² or more cables for the main power line (choose the corresponding main power line according to the load current). If the module power line needs to be lengthened, you must use a wire with a specification above 0.75mm²/18# to avoid overloading and overheating the power line.
(2). The single lamp of the module can be cut. When the module is cut short and connected, first use diagonal pliers to cut the power cord between the two modules in the middle, peel off the outer skin about 10mm, and put the corresponding color ( The positive pole of the red and white line, and the negative pole of the white line) are twisted into one strand, and then insulated and waterproofed with special waterproof tape. Finally, the continuity and reliability of the power terminal are checked, so that the wire cannot be pulled out from the terminal with bare hands. ;
(3). When installing the module, first tear off the adhesive release paper at the bottom of the module, stick it to the light box or the advertising logo for preliminary fixation, and then use a ST2.5x10mm self-tapping screw to lock and reinforce it. The two sides of the module are fixed by glass glue;
(4). The terminal module wires need to be waterproofed with waterproof tape or wiring waterproof plugs to avoid short circuit damage to the product;
(5). The standard cascade of modules is 30PCS. Single-ended power supply; the maximum cascaded 60PCS, power supply at both ends, do not overconnect, to avoid damage to the product due to excessive line load current;
Note: It is recommended to use a switching power supply (with short-circuit protection, over-voltage protection, and over-current protection) that has passed the relevant safety certification.